Do you wish to find out how to reset a DSTV Explora remote A7? This is one of the latest DSTV remote controls. It works on the Explora, which is the company’s current flagship decoder. Resetting your decoder is something that you may wish to do if the device has stopped working. Note that when you carry out a reset, you lose all the settings that you may have programmed into the remote.
How to reset an Explora remote
The following is how to reset a DSTV Explora remote a7;
- Simultaneous press on the Standby buttons on the a7 remote. Keep pressing on the two buttons for about 3 seconds. You will notice two red blinks on the remote.
- Now you need to press on the 9, then 8, then 1 buttons.
- Press on the OK button for at least 3 seconds. The light on the remote will flash 4 times. That shows you that your remote has not be reset to factory defaults.
If the above steps have not been working out
That’s how to reset a DSTV Explora a7 remote. The steps are simple enough. You will be done within a couple of minutes. However, there may be instances where the above steps fail to work.
That’s usually because you have not followed the above instructions as given. Other people have issues because they accidentally press on buttons other than the ones given above. If you do this, you will have to restart the entire process.
You should also not take too long to enter the above code. If you wait 30 seconds between button presses, then the reset will fail. But in general, this is something that anyone can do without having to hire a specialist. You an reset your remote on your own own.
In this article, we showed you how to reset a DSTV Explora a7 remote. We noted that the steps for doing this are simple enough that you should have a reset done in no time.
It was also noted that a reset may become necessary if your remote has not been working properly. However, carrying out a reset removes all the settings that you may have programmed into the device.